Previously, if an I/O qpair is disconnected, we tried reconnecting
the qpair. However, this reconnect operation was very likely to fail
and will not match the upcoming asynchronous connect/reconnect
operation. We need an extra callback to make this reconnect operation
asynchronous, but we do not want to have it.
Hence if an I/O qpair is disconnected, we free the I/O qpair and then
reset the corresponding nvme_ctrlr immediately. If the admin qpair is
also disconnected, the nvme_ctrlr is reset immediately. However this
event may never happen. So we do not wait for the error of the admin
qpair.
The NVMf host may disconnect connections by itself intentionally.
In this case, resetting the nvme_ctrlr will surely fail. But resetting
the nvme_ctrlr frees all I/O qpairs of the nvme_ctrlr and these I/O
qpairs are not created again until resetting the nvme_ctrlr succeeds.
Resetting the nvme_ctrlr once at most is more efficient than repeating
reconnecting the I/O qpair. So this change is valuable even for such
intentional disconnection. However, it is helpful to know the event that
I/O qpair is disconnected. Hence change DEBUGLOG to NOTICELOG in the
disconnected callback. The disconnected callback is not repeated, and
we do not need to worry about NOTICELOG flooding.
Refine the unit test case to verify this change.
Signed-off-by: Shuhei Matsumoto <shuhei.matsumoto.xt@hitachi.com>
Change-Id: I376b749c2f55d010692bf916370e8bb4249b795f
Reviewed-on: https://review.spdk.io/gerrit/c/spdk/spdk/+/9515
Community-CI: Mellanox Build Bot
Community-CI: Broadcom CI <spdk-ci.pdl@broadcom.com>
Tested-by: SPDK CI Jenkins <sys_sgci@intel.com>
Reviewed-by: Aleksey Marchuk <alexeymar@mellanox.com>
Reviewed-by: Jim Harris <james.r.harris@intel.com>
Reviewed-by: Ben Walker <benjamin.walker@intel.com>
49e051965f